Custom Installation Series - Wall Mount
(NEMA) Enclosures

Wiring conduit holes are added at installation as required to the bottom and lower side surfaces of the chassis.

Wall Mount Models (WM) come with a 95 CFM Fan with controlled (normally open) 70°C Thermal Switch.        

WM 75 BAL   75 Amp

Input Voltage and Frequency: Selectable 240V AC (2 x 120VA C, Balanced) or 208V AC. Factory wired for 240V AC. Selectable: 208V AC Range ± 10%, (57-63)Hz.

Input Current Limiting: 40A 2 X Fuses Internal

Input (inlet) connector Rear panel: N/A

Line Cord (included): N/A

Input current rating: 32A

Output voltage: 120V AC

Output Current Limiting: 16A 5 X Circuit Breaker Internal

Output connector: N/A

Surge Suppression: Meets IEEE C62.41-1991: Series mode type; built to withstand 6000 volts, 3000 amps for 1000 repeats; with clamping voltage of 2 volts above peak nominal voltage.

Noise Reduction: Performs as low pass filter, attenuating noise from 2kHz to 1mHz, with attenuation of 12 db/decade to 500 kHz.

Weight: 203 lbs (92.2Kg)

Size (w x d x h) (inch): 27 x 20.5 x 10.5                 Size (w x d x h) (mm): 686 x 521 x 267

Notice:                                                              Installation by qualified electrician required.
These units are designed for fixed, hard-wiring of input and output. Installation and wiring of these units, or any household or facility wiring, should be performed by a licenced electrician to local codes. The final installation should also be inspected and passed by a qualified electrical inspector prior to use.

Internal View