Custom Installation Series - Wall Mount
(NEMA) Enclosures

Series

These models are suitable for custom installations such as studios, new construction, consumer home theatre and audio systems installation where dedicated wiring and lines will be provided. 

All units are designed for 240 Volt Balanced input (2 X 120V), or 208V input.   Output is 120Volt/60 Hz at rated output current
as per model listing below. 

Technical Specification 

Wiring conduit holes are added at installation as required to the bottom and lower side surfaces of the chassis.
Wall Mount Models (WM) come with a 95 CFM Fan with controlled (normally open) 70°C Thermal Switch.  

WM 60 BAL   60 Amp

Input Voltage and Frequency: Selectable 240V AC (2 x 120VA C, Balanced) or 208V AC. Factory wired for 240V AC. Selectable: 208V AC Range ± 10%, (57-63)Hz.

Input Current Limiting: 30A 2 X Fuses Internal

Input (inlet) connector Rear panel: N/A

Line Cord (included): N/A

Input current rating: 24A

Output Voltage: 120V AC

Output Current Limiting: 20A 3 X Circuit Breaker Internal 

Output Current Limiting: N/A

Output connector: N/A

Surge Suppression: Meets IEEE C62.41-1991: Series mode type; built to withstand 6000 volts, 3000 amps for 1000 repeats; with clamping voltage of 2 volts above peak nominal voltage.

Noise Reduction: Performs as low pass filter, attenuating noise from 2kHz to 1mHz, with attenuation of 12 db/decade to 500 kHz.

Weight: 165 lbs (74.9Kg)

RM 15 AVR – 19" Rack Mount Faceplate

Size (w x d x h) (inch): 27 x 20.5 x 10.5 

Size (w x d x h) (mm): 686 x 521 x 267

Notice: Installation by qualified electrician required.
These units are designed for fixed, hard-wiring of input and output. Installation and wiring of these units, or any household or facility wiring, should be performed by a licenced electrician to local codes. The final installation should also be inspected and passed by a qualified electrical inspector prior to use.