RM 100 BAL

Provide Clean AC Power and Surge Suppression that really works

Available in Rack Mount

Torus RM 100 BAL 

Balanced 240V input is provided from two x 120V phases and supplies highest power capability and noise cancellation. The toroidal isolation transformer steps-down the 240V input to 120V to power the equipment. Where 240V is unavailable, the higher power units may be configured for 208V operation. Balanced 240V input does not require the use of failure-prone Ground Fault Circuit Interruption (GFCI) devices.

The models in the Custom Series should be professionally installed by qualified electricians and/or CEDIA certified installers.

Technical Specs

Input Voltage and Frequency: Selectable 240VAC (2 x 120VAC, Balanced) or 208VAC, Factory wired for 240VAC. Selectable: 208VAC Range ± 10% (57-63)Hz

Input Current Limiting: 50A 2 X Fuses Internal

Input (inlet) connector Rear panel:  Twist-Lock 2 Pole 3 Wires grounding 50A 250V

Line Cord (included): Type F (For information on line cords, receptacles, and power inlets, see Customer Care.)

Output voltage: 120V AC

Output Current Limiting: 20A 5 x Circuit Breaker Front Panel

Output connector: Medical Grade Duplex 20A (Qty 12) 24 Outlets

Surge Suppression:  Meets IEEE C62.41-1991: Series mode type; built to withstand 6000 volts, 3000 amps for 1000 repeats; with clamping voltage of 2 volts above peak nominal voltage.

Noise Reduction:  Performs as low pass filter, attenuating noise from 2kHz to 1mHz, with attenuation of 12 db/decade to 500 kHz.

Weight:  220lbs (100Kg)

RM 100 BAL – 19" Rack Mount Faceplate Size (w x d x h) (inch): 19 x 23 x 9.75 Size (w x d x h) (mm): 483 x 584 x 248

CE Approved