Custom Installation Series – Wall Mount (NEMA) Enclosures

Series

These models are suitable for custom installations such as studios, new construction, consumer home theatre and audio systems installation where dedicated wiring and lines will be provided. All units are designed for 240 Volt Balanced input (2 X 120V), or 208V input. Output is 120Volt/60 Hz at rated output current as per model listing below.

Technical Specifications:

Wiring conduit holes are added at installation as required to the bottom and lower side surfaces of the chassis. Wall Mount Models (WM) come with a 95 CFM Fan with controlled (normally open) 70°C Thermal Switch.

WM 60 BAL AVR 60 Amp

Input Voltage and Frequency: Selectable 240V AC (2 x 120VA C, Balanced) or 208V AC. Factory wired for 240V AC. Selectable: 208V AC Range ± 10%, (57-63)Hz.

Input Current Limiting: 30A 2 X Fuses Internal
Input (inlet) connector Rear panel: N/A
Line Cord (included): N/A
Input current rating: 24A
Output Voltage: 120V AC
Output Current Limiting: 20A 3 X Circuit Breaker Internal
Output Current Limiting: N/A
Output connector: N/A

Automatic Voltage Regulation:
Torus AVR provides stable output voltage to keep equipment running in the optimal range of 120VAC ± 5V (115V to 125V) for any input voltage ranging from 170VAC to 270VAC. Torus Power AVR is a full-feature power conditioner, isolating and protecting your system. Like all Torus Power products, the AVR series provides true isolation (using massive toroidal transformers). Torus Power AVR series protects all connected equipment from the risk of severe power line surges using series-mode surge suppression. The models in the Custom Series should be professionally installed by qualified electricians and/or CEDIA certified installers. Surge Suppression: Meets IEEE C62.41-1991: Series mode type; built to
withstand 6000 volts, 3000 amps for 1000 repeats; with clamping voltage of 2 volts
above peak nominal voltage.

Noise Reduction: Performs as low pass filter, attenuating noise from 2kHz to 1mHz, with attenuation of 12 db/decade to 500kHz.
Interfaces: RS232, Ethernet via built-in web browser
Triggers: 2 x 12volt
Weight: 180 lbs (81.8Kg)
Size (w x d x h) (inch): 30 x 24 x 10
Size (w x d x h) (mm): 762 x 610 x 254

Notice: Installation by qualified electrician required.
These units are designed for fixed, hard-wiring of input and output. Installation and wiring of these units, or any household or facility wiring, should be performed by a licenced electrician to local codes. The final installation should also be inspected and passed by a qualified electrical inspector prior to use.